Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Burbank, CA
Garage door installation in Burbank usually runs $700 – $2,200 for a complete new door, and the job is shaped by the city’s older housing stock more than anything else. Most of the garages we see here were built between the 1920s and 1960s, which means non-standard opening sizes, aging wood frames, and sloped driveways that change how a door needs to be measured and hung. San Marcos Garage Door Service has served Burbank since 2012, and we handle the full arc: a new Clopay or Amarr door installed this week, a broken spring replaced today, or a LiftMaster opener repaired on the spot. Call us at (877) 265-5166 for a free estimate.
Why Burbank Homes Are Different
Burbank is a media-company town wrapped around hundreds of 1920s – 1950s single-family bungalows and ranch homes. Most have detached or attached garages reached by short, sloped driveways, and that changes the work in ways a generic door company misses. The original openings are frequently single-car wood or early steel frames, and they rarely match today’s standard panel sizes. In Magnolia Park and the Rancho area, we regularly custom-fit replacements because the rough opening is 7 feet wide when the customer assumed it was 8. Burbank’s Community Development Department is also strict about permitting on replacement doors, especially in hillside and airport-adjacent zones, so accurate opening dimensions and engineering review are part of the local code culture. It’s a city where “measure twice” isn’t a slogan. It’s how you get the permit approved the first time.
The climate adds another layer. Hot, dry summers bake lubricant out of torsion springs and rubber seals. Santa Ana winds push grit into tracks and accelerate weathering on wood doors along the foothill edges. Homeowners in those canyon-edge neighborhoods sometimes ask about non-combustible or fire-rated door materials, and that’s a conversation we have often enough to keep those options in stock.
Styles & brands we work with
Our Main Burbank Services
Two services dominate the call volume from Burbank homeowners: repair and opener repair. Here’s what each involves here.
Garage Door Repair in Burbank
Repair work in Burbank is heavily weighted toward spring failures, cable snaps, and track issues on older doors that have been in service since the Reagan administration. The sloped driveways common in the hillside neighborhoods mean a door that’s slightly off-track wears rollers and hinges faster than it would on a flat approach. We stock torsion and extension springs, cables, rollers, and hinges on the truck, so most repairs are done in one visit. Garage Door Repair in Burbank covers the full breakdown of what we fix and what it costs.
Garage Door Opener Repair in Burbank
Opener repair here skews toward older Chamberlain and LiftMaster units wired into mid-century garages, plus a growing number of Genie and Craftsman systems. Burbank’s heat shortens circuit board life, and the dry air makes safety sensor lenses dusty faster than coastal areas. We diagnose the actual fault before recommending a fix: a gear kit is $120 – $320, a full opener replacement $250 – $550. Garage Door Opener Repair in Burbank has the full pricing and symptom guide.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Garage Door Installation in Burbank
Garage door installation in Burbank is a retrofit business. The city’s housing stock skews to 1920s – 1960s bungalows and ranch homes, so we’re almost never working with a clean, modern opening. We’re working with wood frames that have shifted, openings that are 7’6″ wide instead of 8’0″, and headroom clearances that a standard torsion setup won’t fit. The short, sloped driveways in hillside zones and neighborhoods near the airport’s flight path mean our crew measures side clearance and approach angle before ordering anything. Hot summers and Santa Ana winds also shape material choice: we steer some foothill homeowners toward fire-rated or non-combustible doors. Whether you need a full replacement or a first-time install on a detached garage, Garage Door Installation is the service hub with side-by-side brand comparisons and full product range detail.
Garage Door Replacement
Signs you need it
A door with rotted lower panels, a bent rail, or a spring system that’s failed twice in three years is a replacement candidate, not another patch job.
What it costs in Burbank
A complete garage door replacement in Burbank runs $700 – $2,200 depending on size, material, insulation, and whether the opening needs reframing.
How we do it
We measure the rough opening, check headroom and side clearance, confirm what the Burbank permit office will require, then remove the old door, install the new panels, tracks, springs, and weather seal, and test the full cycle.
Garage Door Installation Service
Signs you need it
New construction, a garage conversion, or an opening that never had a door before all call for a ground-up installation rather than a swap-out.
What it costs in Burbank
New garage door installation in Burbank typically lands between $700 and $2,200, with custom-fit openings on older homes running toward the upper end.
How we do it
We frame and square the opening if needed, mount the track system, hang the door panels, install the spring assembly and opener bracket, then balance the door so it holds at mid-height.
Garage Door Seal Installation
Signs you need it
Daylight visible under the door, leaf litter blowing into the garage, or a puddle forming at the base after rain means the bottom seal or side weatherstripping has failed.
What it costs in Burbank
Seal and weatherstripping work is part of the $150 – $600 garage door repair range, with bottom seal replacement on a single door usually on the lower end.
How we do it
We pull the old seal, clean the retainer channel, cut the new seal to the exact door width, and install it with compatible weatherstripping for Burbank’s dry heat and Santa Ana dust.
What Garage Door Installation Costs in Burbank
| Item | Typical range in Burbank |
|---|---|
| New door installation | $700 – $2,200 |
| Panel replacement | $250 – $500 |
| Opener installation | $250 – $550 |
Do I need a permit to replace a garage door in Burbank?
Burbank’s Community Development Department often requires permit review for replacement doors, especially in hillside and airport-adjacent zones. We handle the measurement documentation the permit office asks for, and we quote the permit line item before any work starts.
Can you install a garage door on a sloped Burbank driveway?
Yes. We measure the approach angle and side clearance before ordering, and we adjust track pitch and panel height so the door clears the slope through its full travel. Call (877) 265-5166 for a free on-site measure.
Brands We Service in Burbank
We work on Clopay, Amarr, Wayne Dalton, and Craftsman doors, plus LiftMaster, Chamberlain, Genie, and Raynor openers. Common parts for these systems are stocked on our trucks and in local inventory, so most Burbank repairs don’t wait on a parts order. See our brands for the full compatibility list.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Burbank, CA
| Service | Typical range in Burbank |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
| Garage door repair | $150 – $600 |
Prices in Burbank push upward when an older opening needs custom panel sizing, when a hillside property requires extra track work for slope clearance, or when the permit office asks for engineering documentation. Whatever the scope, we quote the full price before any work starts and we don’t change it at the invoice unless you add work.
Neighborhoods We Serve in Burbank
We cover the full Burbank area, including 91505, 91506, 91507, and 91508. Most neighborhoods we reach within 60 – 90 minutes for repair calls.
- Magnolia Park
- The Rancho area
- Downtown Burbank (91501/91502)
- Hillside and canyon-edge zones above the Valley floor
- Airport-adjacent neighborhoods
Service Area – Cities Near Burbank
Beyond Burbank, our service area covers the surrounding San Fernando Valley and foothill communities. We work in Universal City, CA, North Hollywood, CA, Glendale, CA, and Studio City, CA, with the same stocked trucks and brand-specific approach.
Serving Burbank, CA — Our Local Coverage Area
We’re based in the Burbank area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Burbank
Most Burbank repair calls are reached within 60 – 90 minutes. Installation and replacement work is scheduled for a measured, written-price visit first, then the install date. Call (877) 265-5166 and tell us the neighborhood; we’ll give you a real arrival window.
Burbank’s Community Development Department often requires permit review on replacement doors, particularly in hillside and airport-adjacent zones. We document the opening dimensions and engineering details the permit office asks for, so you’re not stuck chasing paperwork.
Yes. Non-standard openings are the norm here, not the exception. We measure the actual rough opening on site, order custom-fit panels when needed, and quote the modification cost before any work begins. The price you agree to is the price you pay.
Need a spring repaired today or a full new door quoted for your Burbank garage? Call San Marcos Garage Door Service at (877) 265-5166 for a free estimate. We’ll name the part, explain the fix, and get your door moving again.
What happens when you call
- 1A real person answersNo phone trees — talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Burbank Customers Say
"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
— Angela Lin"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
— Karen Park"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
— Lisa Brooks